AT-OC9XEN

369,00€ VAT incl.

Dual moving coil stereo cartridge with Elliptical nude stylus

  • Features low mass nude elliptical stylus and aluminium cantilever
  • A neodymium magnet and pure iron yoke provide increased magnetic energy
  • Features threaded inserts in the cartridge body
  • Aluminium body minimizes unwanted vibration for reduced resonance
  • PCOCC is used for the coils to achieve pure signal transmission

Shipping to France offered from 250€

Categories: , Tag: Brand:

The next Generation of the legendary OC9 cartridge series

Since its introduction more than 30 years ago, Audio-Technica’s pioneering moving coil OC9 cartridge series has been prized by demanding vinyl listeners and professional critics alike for its musical transparency, expression of sound and precise construction. Featuring a square shank for accurate stylus alignment and nude diamond for increased fine detail retrieval.

  • Features low mass nude elliptical stylus and aluminium cantilever
  • A neodymium magnet and pure iron yoke provide increased magnetic energy
  • Threaded inserts in the cartridge body enable the cartridge to be mounted on to the headshell or integral tonearm with just two screws – no nuts required
  • Aluminium body minimizes unwanted vibration for reduced resonance and a superior audio reproduction
  • Pure Copper by Ohno Continuous Casting process (PCOCC) is used for the coils to achieve the purest signal possible
Model AT-OC9XEN
Mounting 1/2” centers / Threaded inserts
Frequency Response 20 – 30,000 Hz
Body Material Aluminium
Channel Separation 25 dB (1 kHz)
Output Channel Balance 1.5 dB (1 kHz)
Output Voltage 0.35 mV (@ 1 kHz, 5 cm/sec)
Vertical Tracking Angle 20 degrees
Vertical Tracking Force Range 1.8 to 2.2 g (standard 2.0 g)
Stylus Shape Elliptical Nude
Stylus Size 0.3 x 0.7 mil
Stylus Construction Nude square shank
Cantilever Aluminium pipe
Coil Impedance 12 Ohms (1 kHz)
Coil Inductance 25 μH (1 kHz)
DC Resistance 12 Ohms
Static Compliance 20 x 10 – 6 cm / dyne
Dynamic Compliance 9 x 10 – 6 cm / dyne (100 Hz)
Terminal Pins Brass
Wire Used for Coil PCOCC (Copper by Ohno Continuous Casting process.)
Recommended Load Impedance Min 100 Ohms
Cartridge Weight 7.6 g
Dimensions 17.3 (H) x 16.8 (W) x 25.7 (L) mm
Accessories Included 1 non magnetic screw driver
1 brush
2 washers
4 pairs of mounting screws: 5mm, 8mm, 10mm, 12mm
1 plastic protector